Carl-goldberg GPMA1940 EP Falcon ARF Bedienungsanleitung

Champaign, Illinois(217) 398-8970, Ext [email protected]© 2010 Hobbico®, Inc. GPMA1940 MnlREAD THROUGH THIS MANUAL BEFORE STARTING CONSTRUCT

10 ❏ 4. If building the indoor wing, simply stick the plastic rubber band protectors to the top of the wing at the leading and trailing edges where s

11 ❏ 9. Use a few dabs of clear RTV silicone, R/C 56 canopy glue or double-sided adhesive tape to hold the canopy to the top of the wing or to the dou

12These are the recommended control surface throws:ELEVATORHIGH RATE LOW RATE3/4"[19mm]28°Up5/8"[16mm]23°Down1/2"[13mm]13°Up3/8"[1

13 ❏ 3. If any weight is required to get your Falcon to balance, determine how much by placing segments of Great Planes “stick on” lead (GPMQ4485) ove

14To takeoff from the ground, simply set the model down facing directly into any prevailing breeze. Smoothly, but rapidly advance the throttle all the

15C.G. Marking TemplateAlign with leadingedge of wingAft C.G.3.0" [76mm]2-5/8" [67mm]2-1/4" [57mm]Forward C.G.Recommended C.G.Aft C.G.3

®®

2INTRODUCTIONINTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2AMA . . . . . . . . . . . . . . . . . . . . . . . . . . .

3We, as the kit manufacturer, provide you with a top quality, thoroughly tested kit and instructions, but ultimately the quality and fl yability of you

4 1. Fuselage 2. Vertical Stabilizer 3. Horizontal Stabilizer 4. Wing 5. Aileron Pushrods 6. Rudder/Elevator Pushrods 7. Wing Center Doubler 8.

5ASSEMBLE THE FUSELAGEInstall the Horizontal andVertical Stabilizer ❏ 1. Carefully fl ex the elevator up and down several times to loosen the hinge. ❏

6❏ 5. Carfully fi t the stab/fi n into the fuselage. Make sure the bottom of the fi n is fully keyed into the slot in the bottom of the fuselage and that

7Pressed all the way downNo Yes ❏ 4. Center the trims and connect a battery to the ESC to power the system up. Mount the servo arms 90°—or as close to

8 Refer to this photo for the following three steps.❏ 2. With the ESC connected to the receiver, guide the three motor wires from the ESC down through

9ASSEMBLE THE WINGHook Up the Ailerons1.0mm screwsOffset servo armServo arm thatcame with servo❏ 1. Use two of the tiny wood screws included with this