Extra 330 ARFExtra 330 ARFWARNINGA radio-controlled model is not a toy and is not intended for persons under 16 years old. Keepthis kit out of the re
104. Remove the top canopy hatch. Reach downinside the fuselage and pull the cables slowlyfroward.Caution: Do not pull the cables all the waythrough
11INSTALLING MAIN LANDING GEAR1. Collect the following items:(4) 3mm x 15 phillips Head Screw(4) 3mm Lock Nut(1) Main Aluminum Landing Gear2. Remo
12Wheel CollarsWheel PantWheelLanding Gear7. Mount the wheel pants back on the landinggear along with the wheel collars and wheels.8. Center the wheel
132. Drill a 1/8” hole in the firewall in position withthe throttle arm. Insert the 1/8” x 16” nylontubing in the hole. Let the tubing exit into
142. Insert the brass tubes through three of theholes. They should be arranged so as the longone will be on the right side of the plane andthe short
153. Place the hatch cover over the motor box.Drill holes thought the hatch into the endsof the motor box sides. Attach the hatch using the #2 x 5
162. Slide the wing tube into one of the winghalves. Slide the tube thru the fuselage. Slide the second wing half onto the wing tubecoming out of
17FLYING YOUR EXTRA 330 ARFFully-charged flight batteriesRadio transmitter1 ½ volt starting battery & glo-plug clipFuel bulb or pumpTools for ti
18
19
2Congratulations on your purchase of the Extra330ARF. This is a very unique dual-purpose air-craft, capable of flying any FAI patternsequence with eas
20
3ADHESIVES & GLUING TECHNIQUESCA adhesives are specially formulated to firmly glue theplywood, hardwood, and balsa used in your model and towithst
42. Locate the pre-drilled aileron hinge holes in bothwing halves. Using a 1/4” drill, drill each hole1/8” deep. This will allow the center of the
53. Attach the 24” “Y” harness to one of the servos.IMPORTANT! To ensure that any connections locat-ed inside the wing will not come loose, either w
63. Position the control horn bolt so that it is 1/2”back from the hinge line on the mark that youjust made.4. Using a 9/64" drill bit, make a
7Gluing Stabilizer:1. Using a pencil, make an outline where thestabilizer rest against the fuselage.2. Remove both stabilizers from the tubes.3. Remov
82. Plug the 24” extensions into the elevator ser-vos. Make sure that the extensions plugs are tapedto the servos.3. Screw the elevator servos int
95. Thread the 2 white adjustable horn bracketson the rod. Do this on both sides of the bolt.6. Thread the 6-32 x 3” threaded rod half wayinto t
Kommentare zu diesen Handbüchern