Surge 400WARNINGA radio-controlled model is not a toy and is not intended for persons under 16 years old. Keepthis kit out of the reach of younger ch
2USING THIS INSTRUCTION MANUALBefore you begin assembling your Surge 400 ARF, takesome time to read through this entire instruction book. It isdesign
3ITEMS NEEDED TO COMPLETE THIS AIRCRAFT* 1 5 CHANNEL RADIO WITH 6 MICRO SER-VOS. (WE USED 6 CHANNEL FUTABARADIO WITH S3108 SERVOS AND GREATPLANES ELEC
4Installing Ailerons & Flaps1. * Collect the following parts:(1) Wing(2) Ailerons ( Left & Right)(2) Flaps ( Left & Right)(10) Mini CA hin
52. * Remove the covering on both the ailerons &the flaps, where the control horn slots arelocated.* Using CA glue, attach the control horns to th
6“X”“X”4. *Measure from the end of the wing to the tip ofthe stab. This measurement should be thesame for both sides.* Mark the stabilizer where it re
72. * Locate the slot in the rudder near the bottom.* Remove the covering over the slot.* Attach the EZ connector to the control hornwith the adjustin
8Installing Motor & ESC1. * Collect the following parts:(1) Fuselage(1) Motor with Gear Drive (Not Included)(1) Electronic Speed Control (Not Incl
92. * Mount the elevator and rudder servo asshown above.*Attach the pushrods to the servo arms thesame way you did the aileron servos.* Mount the two
Kommentare zu diesen Handbüchern